When ordering replacement parts, make sure you get the correct parts from your hardware store or online retailer. If the heating element doesn’t have continuity, it will need to be replaced. Finally, test the heating element with the multimeter.If the fuse is defective, you will need to order a replacement part. Next, test the heating fuse with your multimeter.If defective, you will need to order replacement parts. This can be done by using your multimeter to test each to see if they have continuity. Here’s how to test the heating element, sensors, and heating fuse: If you don’t have a multimeter or if you know the element is defective, you can skip this step and remove the heating element. Sometimes, you might think the heating element is faulty when it could just be a faulty sensor or heating fuse. If you have a multimeter, it’s a good idea to test the heating element, the two sensors, and the heating fuse to make sure they are working or not. Step 3 – Test the heating element, sensors, and fuses (optional) You should now be able to remove the dryer housing and you’ll have access to the heating element. Check if the housing has any screws securing it to the dryer, and if so, unthread them.Once both sensors have been removed, locate the heating fuse (it’s usually on the left-hand side of the housing unit) and remove it by disconnecting the wires and unthreading the screws that hold it in place.Next, remove the second sensor that’s on the bottom of the housing by disconnecting the wires and unthreading the screws that hold it in place.On top of the housing is a black sensor-remove this sensor by disconnecting the wires and unthreading the screws that hold it in place. At the back of your dryer, you should be able to see a long metal housing unit that protects the heating element.You’ll need to unthread the screws and then the panel should clip off. Disconnect the exhaust hose from the back of your dryer.This is an important safety measure as you’re going to be dealing with electrical components within the dryer. The first step is to switch the power off to your dryer at the wall or turn the circuit breaker off. In this article, we will give you step-by-step instructions for how to test the heating element to ensure it’s defective, remove the old element, and finally install the new one. Thankfully, fixing a heating element in a dryer is relatively straightforward and can be carried out by people with good DIY skills. When this happens, the heating element needs to be replaced. If your dryer isn’t heating to a high enough temperature or not at all, it could be due to the heating element becoming defective.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |